Frigidaire builds value-oriented refrigerators, and the trade-off shows up in a handful of predictable places: the defrost system (heater and defrost thermostat), the evaporator fan, the ice maker, door gaskets, and the start relay on the compressor. These are straightforward mechanical and electrical parts, which is actually good news — when a Frigidaire stops cooling, the cause is usually one inexpensive component rather than a sealed-system failure. Side-by-side and top-freezer models share most of the same weak points, so we see the same repairs again and again.
We don't guess at parts. The technician pulls the panel, checks the evaporator for the frost pattern that tells the real story, and tests the heater, thermostat, fan, and relay with a meter before recommending anything. You get a written quote based on what actually failed, not on what commonly fails.
Frigidaire refrigerator not cooling but running
A Frigidaire that hums along but slowly warms up almost always has a defrost problem. When the defrost heater or defrost thermostat fails, frost builds on the evaporator coil until air can no longer pass through it — the freezer stays cold longest while the fresh food section drifts warm. We confirm it by inspecting the coil and testing both components for continuity rather than replacing them on suspicion.
Frigidaire refrigerator clicking but compressor won't start
A repeating click every few minutes from the back of the cabinet usually points to the start relay on the compressor — a cheap part that fails far more often than the compressor itself. We test the relay and the compressor windings separately, so you know whether you're facing a small repair or a bigger decision before spending anything on parts.
Frigidaire ice maker not making ice
Frigidaire ice makers stop for a short list of reasons: the water inlet valve weakens and can't push enough water into the mold, the fill tube freezes solid, or the ice maker module itself gives out. We check water pressure and the valve first, since replacing an ice maker when the real problem is the fill side just moves the failure down the road.
Frigidaire freezer frosting up or leaking water inside
Heavy frost on the back wall and water pooling under the drawers come from two related problems: a defrost cycle that isn't finishing its job, or a defrost drain that's iced over so meltwater has nowhere to go. Door gaskets matter here too — a hardened or torn gasket lets humid air in constantly, and no defrost system keeps up with that.
Independent Frigidaire service, tested before quoted
PV Appliance Repair is an independent, insured service company — we are not affiliated with or certified by Frigidaire, and we never present ordinary trade experience as factory authorization. What you get instead: a technician tests the actual failure, explains the finding, and gives you a written quote before any work starts. The service call is waived when you approve and complete the repair, and if we can't fix it, you don't pay. Every completed repair carries a 90-day warranty on the documented work and installed part.